• Add Review
  • Subscribe
  • Nominate
  • Submit Media
  • RSS
Not the best, but I managed to make a sleeping sprite! :-)
  • AceOfAces
  • Added: 02/28/2016 08:24 PM
  • Last updated: 04/18/2024 12:26 AM
  • 1764 views

Posts

Pages: 1
You could make an edit of the bed sprite that would show the blanket above the sprite. It's pretty simple to do! Just copy that particular tile to another spot on the tileset in an image editor, then zoom in and remove everything above the edge of the blanket. Then put the top half of the bed on the A5 tile and the edit on a B-E tile. Make sure to set that B-E tile to above hero and the A5 tile as below hero, then you can put the A5 tile down and put the B-E tile above it and any sprite in that spot will look like they're under the blankets. ^.^)b

You'r house is a little on the big side since it's pretty empty. You could actually fix that easily enough by moving the wall separating the kitchen from the bookshelf areas down one more tile, then having a carpet under the table. Also, take one of the top parts of the bookshelves/shelves and move it down on the grid of the tileset until you can only see the top (and not the actual shelf parts), then put it in its own spot and make it set to above hero. Use it against the bottom walls to give the illusion that there's shelves behind the walls that can't be seen fully due to the walls being in the way.

Also, Hold shift when placing that carpet in the room (the tile just in front of the doorway) and then click on the bottom part so that it looks like the carpet goes behind the walls instead of looking like it was cut to just fit through that gap (which is weird).
AceOfAces
Engineering to infinity!
2138
author=Liberty
You could make an edit of the bed sprite that would show the blanket above the sprite. It's pretty simple to do! Just copy that particular tile to another spot on the tileset in an image editor, then zoom in and remove everything above the edge of the blanket. Then put the top half of the bed on the A5 tile and the edit on a B-E tile. Make sure to set that B-E tile to above hero and the A5 tile as below hero, then you can put the A5 tile down and put the B-E tile above it and any sprite in that spot will look like they're under the blankets. ^.^)b


Well, I already did that (as shown here, I forgot to upload a new one for feedback.)

I'll see what I can do with the rest. Thank you for the feedback.
Pages: 1